0Y310ZZ
Control Buttock, Left to No Qualifier with No Device, Open Approach
Procedural Specifications
| Clinical Axis | Detail Definition |
|---|---|
| Section | 0 Medical and Surgical |
| Body System | Y Anatomical Regions, Lower Extremities |
| Operation | 3 Control |
| Body Part | 1 Buttock, Left |
| Approach | 0 Open |
| Device | Z No Device |
| Qualifier | Z No Qualifier |
Operation Definition
Stopping, or attempting to stop, postprocedural or other acute bleeding
Procedure Overview
Control procedures address bleeding in the lower extremity that occurs after a prior procedure or from another acute cause, when the bleeding itself, rather than an underlying disease process, is the problem being treated. This might involve returning to the operating room after a hip, knee, or vascular procedure to stop bleeding from a surgical site, or addressing acute bleeding from trauma to the leg or foot.
Patients need this kind of intervention when a wound or surgical site continues to bleed despite initial measures, requiring a clinician to reopen or directly address the site to achieve hemostasis. The techniques used can include direct pressure, cautery, suture ligation, or packing, and the choice depends on the location and severity of the bleeding.
Because postoperative bleeding can signal a serious complication, timely control is important to prevent blood loss, hematoma formation, and further complications, and successful treatment allows the underlying surgical or traumatic issue to heal without ongoing hemorrhage.
Anatomy & Axis Detail
Buttock, Left
In the left buttock, Control is used when a surgeon must stop bleeding arising from the gluteal soft tissues themselves, commonly following blunt trauma, an injection-related vascular injury, or as a complication of gluteal implant or fat-grafting surgery in a region well supplied by the gluteal arterial branches. Hemorrhage in this muscular region can track along fascial planes and produce a large, deep hematoma before becoming clinically apparent, so control procedures often require wide exploration and evacuation in addition to achieving hemostasis. Coders should confirm that the bleeding was not already addressed as an integral part of another procedure performed at the same operative session, since control is reported only when hemostasis is the primary reason for returning to or extending the operation.
Approach: Open
Open approach means the surgeon cuts through skin, mucous membrane, or other tissue layers to physically expose the target site to view before performing the procedure. It gives direct visualization and hands-on access, distinguishing it from Percutaneous approaches where instruments pass through a small puncture without exposing the site. Open is typical for procedures needing wide access, such as most laparotomies.
Coding & Documentation
A Control code applies specifically when the physician's intent, as stated in the operative note, is to stop bleeding rather than to repair, resect, or otherwise treat an anatomic structure, and the site is coded as an anatomical region rather than a specific organ or vessel when the exact bleeding source is not identified. If the surgeon identifies and repairs a specific bleeding vessel by name, coding guidelines direct the coder to code that specific repair rather than Control.
The most common assignment mistake is defaulting to Control whenever a word like hemostasis appears in a note, even when the documentation actually describes a more specific repair of a named vessel, which should be coded to Repair or another applicable root operation instead. Coders also need to distinguish bleeding controlled during the original procedure, which is not separately coded, from a return to the operating room for bleeding after the fact, which is when Control becomes reportable.