0RGM34Z
Fusion Elbow Joint, Left to No Qualifier with Internal Fixation Device, Percutaneous Approach
Procedural Specifications
| Clinical Axis | Detail Definition |
|---|---|
| Section | 0 Medical and Surgical |
| Body System | R Upper Joints |
| Operation | G Fusion |
| Body Part | M Elbow Joint, Left |
| Approach | 3 Percutaneous |
| Device | 4 Internal Fixation Device |
| Qualifier | Z No Qualifier |
Operation Definition
Joining together portions of an articular body part rendering the articular body part immobile
Procedure Overview
Fusion procedures permanently join the bones of a joint together so it can no longer move, a technique most often applied to small joints of the wrist and fingers, or occasionally the shoulder, when arthritis, instability, or severe deformity has made the joint too painful or unreliable to preserve. By eliminating motion at that single joint, fusion is intended to relieve pain and restore stability, accepting stiffness in exchange for a more predictable, load-bearing joint.
Surgeons commonly perform fusion for advanced wrist arthritis, for a badly damaged finger joint following trauma or rheumatoid disease, or as a salvage option after a failed joint replacement. The bones are prepared, aligned, and held together with hardware such as plates, screws, wires, or a bone graft while the surfaces knit into a single solid unit over subsequent months.
Anatomy & Axis Detail
Elbow Joint, Left
The left elbow joint, formed by the articulation of the humerus with the radius and ulna, allows flexion-extension and contributes to forearm rotation, with the ulnar nerve running in close proximity along its medial aspect throughout the joint's course. As with the right side, fusion here is reserved for end-stage arthritis, chronic infection, tumor involvement, or failed arthroplasty where no reconstructive option remains, and the procedure trades the elbow's flexion-extension arc for stability at a fixed, functionally chosen angle. Careful intraoperative protection of the ulnar nerve is essential given its vulnerable course near the medial epicondyle. Documentation should specify the angle of fusion selected to optimize hand positioning for daily activities, the hardware construct used, and left-sided laterality to distinguish it from the contralateral procedure.
Approach: Percutaneous
Percutaneous describes entry by needle or instrument puncture through the skin or mucous membrane to reach the site of the procedure, without cutting the tissue open or using a visualizing scope. It differs from Open in that the site itself is never exposed, and from Percutaneous Endoscopic in that no endoscope is used to see internal structures. Common examples include needle biopsies and injections.
Device: Internal Fixation Device
Internal fixation device is the general value for hardware such as plates, screws, or rods placed within the body to stabilize bone or joint, used when a more specific configuration is not indicated. It stands in contrast to the named subtypes - Rigid Plate, Intramedullary, Sustained Compression, and Intramedullary Limb Lengthening - which specify how the hardware achieves stabilization.
Coding & Documentation
The coder must identify the specific joint fused, the approach (open, percutaneous, or percutaneous endoscopic), and the device qualifier reflecting what was used to hold the joint immobile, whether internal fixation, a bone graft from the patient's own body, synthetic substitute, or a combination of graft and internal fixation. A frequent error is choosing the wrong device qualifier when both an autograft and hardware are used together, since ICD-10-PCS has a specific combination qualifier for that scenario rather than defaulting to just "internal fixation device." Another common oversight is failing to code the bone graft harvest separately when it is taken from a different, non-contiguous body part.