0SHD38Z
Insertion Knee Joint, Left to No Qualifier with Spacer, Percutaneous Approach
Procedural Specifications
| Clinical Axis | Detail Definition |
|---|---|
| Section | 0 Medical and Surgical |
| Body System | S Lower Joints |
| Operation | H Insertion |
| Body Part | D Knee Joint, Left |
| Approach | 3 Percutaneous |
| Device | 8 Spacer |
| Qualifier | Z No Qualifier |
Operation Definition
Putting in a nonbiological appliance that monitors, assists, performs, or prevents a physiological function but does not physically take the place of a body part
Procedure Overview
This family covers procedures that place a nonbiological device into a joint of the lower body - the lumbar, sacral, or coccygeal spine, hip, knee, ankle, or a joint of the foot - without removing or replacing any of the joint's own anatomy. The device stays behind to support, stabilize, or monitor the joint rather than to act as a substitute for bone or cartilage that has been taken out. Examples include interspinous process spacers placed between vertebrae to relieve nerve compression, internal fixation hardware such as screws or pins used to stabilize a joint after injury, and leads for neurostimulators placed near a joint to manage chronic pain.
Patients typically undergo these procedures for spinal stenosis, joint instability following trauma, or chronic pain that has not responded to conservative treatment. Because the device is added to existing anatomy rather than replacing it, recovery generally focuses on protecting the joint while it adapts to the new hardware.
Anatomy & Axis Detail
Knee Joint, Left
The left knee joint, like its counterpart, unites the femoral condyles, tibial plateau, and patella within a synovial capsule supported by the anterior and posterior cruciate ligaments and the medial and lateral menisci. Insertion procedures here typically place non-biological or antibiotic-impregnated material into the joint space itself, commonly as an interim step in staged revision of a failed or infected prosthesis rather than as a permanent structural repair. The joint's superficial position allows relatively direct surgical access, though care is taken around the popliteal neurovascular bundle posteriorly. Because knee arthritis and injury patterns often differ between limbs, accurate laterality supports correct tracking of the affected side over successive encounters.
Approach: Percutaneous
Percutaneous describes entry by needle or instrument puncture through the skin or mucous membrane to reach the site of the procedure, without cutting the tissue open or using a visualizing scope. It differs from Open in that the site itself is never exposed, and from Percutaneous Endoscopic in that no endoscope is used to see internal structures. Common examples include needle biopsies and injections.
Device: Spacer
In Medical and Surgical procedures, a Spacer is a temporary, non-articulating device left in a joint or space after a component is removed, most often an antibiotic-impregnated cement block placed during a staged joint revision to control infection while preserving space and alignment. It is not intended to move like a real joint. It differs from an Articulating Spacer, which is shaped to permit some motion during the interim period, and from a permanent Synthetic Substitute.
Coding & Documentation
A coder needs operative documentation confirming that a device was placed into the joint and left in place, with no accompanying excision or replacement of joint tissue - if tissue is also being replaced, Replacement rather than Insertion applies. The device type and specific joint (by vertebral level or named lower joint) must be documented to select the correct body part and device value. A frequent error is coding Insertion when a fixation device is actually part of a fusion procedure; if the hardware is placed to achieve fusion, the fusion root operation captures the device and Insertion should not be coded separately. Another common mistake is misidentifying the joint level, especially in multi-level spinal cases where each level may require its own code.
