ICD-10-PCS Billable Code

0DHP0DZ

Insertion Rectum to No Qualifier with Intraluminal Device, Open Approach

Procedural Specifications

Clinical Axis Detail Definition
Section0 Medical and Surgical
Body SystemD Gastrointestinal System
OperationH Insertion
Body PartP Rectum
Approach0 Open
DeviceD Intraluminal Device
QualifierZ No Qualifier

Operation Definition

Putting in a nonbiological appliance that monitors, assists, performs, or prevents a physiological function but does not physically take the place of a body part

Procedure Overview

Insertion procedures in the gastrointestinal system place a nonbiological device into an organ to monitor, assist, or support its function, without replacing any part of the organ itself. Common examples include placing a feeding tube directly into the stomach or jejunum, inserting a drainage tube, or positioning an esophageal or intestinal stent to hold a narrowed passage open. The device stays in the body to perform an ongoing job rather than being used once and removed.

These procedures are chosen when a patient cannot eat normally and needs a route for nutrition, when a passage has narrowed and needs mechanical support to stay open, or when an area needs continuous drainage or decompression. Because the device remains in place afterward, insertion procedures often set up longer-term management rather than resolving the underlying condition outright - a stent may keep an esophagus open, but it does not treat whatever caused the narrowing.

Anatomy & Axis Detail

Rectum

The rectum is the final several centimeters of large bowel, ending at the anorectal junction and sitting deep in the pelvis against the sacrum, bladder or prostate, and vagina. Devices are placed into it for drainage of a postoperative or abscess cavity, for temporary decompression above a low anastomosis, or as a self-expanding stent to relieve obstruction from an unresectable rectal tumor or extrinsic compression. Because the rectal wall is thin below the peritoneal reflection and surrounded by dense pelvic structures, placement is usually done endoscopically or digitally rather than through an open approach, and the device is sized to avoid pressure necrosis against the wall. Documentation should specify the device type and confirm it is left in place rather than removed at the end of the encounter.

Approach: Open

Open approach means the surgeon cuts through skin, mucous membrane, or other tissue layers to physically expose the target site to view before performing the procedure. It gives direct visualization and hands-on access, distinguishing it from Percutaneous approaches where instruments pass through a small puncture without exposing the site. Open is typical for procedures needing wide access, such as most laparotomies.

Device: Intraluminal Device

Intraluminal Device denotes a single device, such as a stent or occlusion device, positioned within the lumen of a tubular body part like a vessel, duct, or airway to maintain patency or occlude flow. It carries no drug coating or radioactivity, distinguishing it from the drug-eluting, radioactive, and bioactive intraluminal device values, and from Extraluminal Device, which sits outside rather than inside the lumen.

Coding & Documentation

Coding an insertion accurately requires documentation naming the specific device placed - a gastrostomy tube, jejunostomy tube, esophageal stent, or drain - along with the exact GI site where it was positioned. The device type matters because it determines the applicable device value in the code, so vague documentation like "tube placed" without specifying the device and location can block accurate code assignment.

A frequent error is coding an insertion when a device was actually replaced rather than newly placed, which instead falls under the Change or Removal-then-Insertion combination depending on the approach used. Coders also sometimes miss that a stent placed to relieve an obstruction during the same session as a diagnostic endoscopy needs its own separate code rather than being bundled into the endoscopic procedure.

Commonly Confused With

ReplacementInsertion is distinct from Replacement, which substitutes biological or synthetic material for a body part rather than adding a monitoring or supportive device alongside existing anatomy - a stent insertion is not a replacement even though both involve placing material in the GI tract.
DrainageIt is also distinguished from Drainage, which takes fluid out of a body part, even when a drainage catheter is left in place afterward - the initial placement of that catheter is coded as Insertion, while the fluid removal itself is Drainage.
RemovalCoders should pair Insertion codes correctly with any related Removal or Change codes if the device is later taken out or swapped.