03L93CZ
Occlusion Ulnar Artery, Right to No Qualifier with Extraluminal Device, Percutaneous Approach
Procedural Specifications
| Clinical Axis | Detail Definition |
|---|---|
| Section | 0 Medical and Surgical |
| Body System | 3 Upper Arteries |
| Operation | L Occlusion |
| Body Part | 9 Ulnar Artery, Right |
| Approach | 3 Percutaneous |
| Device | C Extraluminal Device |
| Qualifier | Z No Qualifier |
Operation Definition
Completely closing an orifice or the lumen of a tubular body part
Procedure Overview
Occlusion procedures on the upper arteries close off the lumen of a vessel completely, cutting off blood flow through that specific segment. Surgeons and interventional specialists use this approach to stop bleeding, seal off an aneurysm, or block blood supply to a tumor or an abnormal tangle of vessels before it can cause harm. The upper arteries covered here include branches such as the innominate, subclavian, axillary, brachial, and the vessels supplying the head, neck, and upper limb.
A common reason for occluding one of these arteries is to treat an aneurysm that cannot be safely repaired by reinforcing its wall. Instead, the vessel feeding it is sealed so pressure inside the bulge drops and the risk of rupture falls. Occlusion is also used to control hemorrhage after trauma, to manage arteriovenous malformations, or to reduce blood flow to a vascular tumor before it is surgically removed, making the operation less bloody.
The closure itself may be achieved with a clip, a ligature, coils delivered through a catheter, or an injected embolic agent, and it can be done through an open incision or a minimally invasive endovascular route.
Anatomy & Axis Detail
Ulnar Artery, Right
The right ulnar artery is one of the two terminal branches of the brachial artery, running along the medial forearm to supply the wrist and hand, particularly through the superficial palmar arch. Occlusion of this artery is most often performed to manage hypothenar hammer syndrome, a traumatic injury, an aneurysm, or an arteriovenous fistula, and it may also be undertaken when the vessel is found to be a source of digital embolization affecting the hand. Because the ulnar artery contributes significantly to hand perfusion through the palmar arches, its patency and that of the radial artery are often assessed together before any planned occlusion to ensure adequate collateral flow will be maintained. Access for occlusion is generally through a direct incision over the distal forearm or wrist, or via a percutaneous catheter-based approach for more central lesions.
Approach: Percutaneous
Percutaneous describes entry by needle or instrument puncture through the skin or mucous membrane to reach the site of the procedure, without cutting the tissue open or using a visualizing scope. It differs from Open in that the site itself is never exposed, and from Percutaneous Endoscopic in that no endoscope is used to see internal structures. Common examples include needle biopsies and injections.
Device: Extraluminal Device
Extraluminal Device describes a device positioned on the outside surface of a tubular or hollow body part rather than within its lumen, such as a vascular banding or external stabilization device. It is the structural counterpart to Intraluminal Device, distinguished by its external placement relative to the vessel or duct wall rather than sitting inside the passageway itself.
Coding & Documentation
A coder selects an Occlusion code when the documentation shows the vessel's lumen is being shut down entirely, not narrowed or reinforced. The operative note needs to state which specific upper artery branch was targeted, the method used to achieve closure (clip, coil, plug, embolic material, or suture ligation), and whether the approach was open, percutaneous, or percutaneous endoscopic, since that determines the approach character of the code.
The most frequent assignment error is confusing Occlusion with Restriction, which only narrows the lumen rather than closing it off completely; the physician's language about "partial" versus "complete" closure is the deciding factor and should be confirmed rather than assumed. Another common mistake is missing that embolization procedures, though performed under interventional radiology, still map to Occlusion when the intent is total vessel closure, and coders sometimes miscode the device value when a liquid embolic agent is used instead of an intraluminal device.