0VPM7CZ
Removal Epididymis and Spermatic Cord to No Qualifier with Extraluminal Device, Via Natural or Artificial Opening Approach
Procedural Specifications
| Clinical Axis | Detail Definition |
|---|---|
| Section | 0 Medical and Surgical |
| Body System | V Male Reproductive System |
| Operation | P Removal |
| Body Part | M Epididymis and Spermatic Cord |
| Approach | 7 Via Natural or Artificial Opening |
| Device | C Extraluminal Device |
| Qualifier | Z No Qualifier |
Operation Definition
Taking out or off a device from a body part
Procedure Overview
Removal procedures in this family involve taking out a device that was previously placed in a structure of the male reproductive system, such as a penile prosthesis, testicular prosthesis, or a drain, rather than treating native tissue. These are performed when a device has served its purpose, malfunctioned, become infected, or needs to be exchanged for a different device.
Patients encounter these procedures most often after a prior implant surgery, such as removal of a penile implant due to mechanical failure, erosion, or infection, or removal of a testicular prosthesis that was placed after orchiectomy. Depending on the reason for removal, a new device may or may not be placed during the same operative session, which affects how the encounter is coded overall.
Anatomy & Axis Detail
Epididymis and Spermatic Cord
For the epididymis and spermatic cord, Removal denotes extraction of a previously inserted device, such as a vasectomy occlusion clip, spring, or valve used for reversible contraception, or hardware left from a prior reconstructive procedure. The epididymis is the coiled duct atop the testis where sperm mature and are stored, while the spermatic cord bundles the vas deferens, vessels, and nerves as they course from the scrotum through the inguinal canal; devices here are typically small and situated close to delicate, easily disrupted structures. Removal may be pursued to restore fertility after a clip-based sterilization procedure, to address device migration or discomfort, or in preparation for a different intervention. Because the cord and epididymis are intimately associated with the testicular blood supply, careful dissection is needed to avoid compromising testicular viability, and coders should confirm from the operative note which specific device and anatomic component were involved.
Approach: Via Natural or Artificial Opening
Via Natural or Artificial Opening means the instrument reaches the target site by passing through an existing body orifice, such as the mouth or urethra, or a surgically created opening like a stoma, without additional incision or scope guidance. It is distinguished from the Endoscopic variant by the absence of a visualizing scope, and from External by actually traversing into the body through that opening.
Device: Extraluminal Device
Extraluminal Device describes a device positioned on the outside surface of a tubular or hollow body part rather than within its lumen, such as a vascular banding or external stabilization device. It is the structural counterpart to Intraluminal Device, distinguished by its external placement relative to the vessel or duct wall rather than sitting inside the passageway itself.
Coding & Documentation
A Removal code is assigned only when a device is being taken out and documentation confirms no new device is being put in through the same procedure; if a device is removed and immediately replaced, coders instead consider whether Revision or a Removal-plus-Insertion combination better reflects what was documented. The operative note should name the specific device removed, such as inflatable penile prosthesis components or a testicular implant, and confirm complete extraction.
A common mistake is coding Removal when the physician actually performed a Revision, which corrects or adjusts a malfunctioning device without full removal and replacement, or when a device is removed and a new one is placed in the same operative episode, which requires reporting both Removal and Insertion rather than Removal alone. Coders should also verify the body part reflects where the device was located rather than the device type itself.