0RPV35Z
Removal Metacarpophalangeal Joint, Left to No Qualifier with External Fixation Device, Percutaneous Approach
Procedural Specifications
| Clinical Axis | Detail Definition |
|---|---|
| Section | 0 Medical and Surgical |
| Body System | R Upper Joints |
| Operation | P Removal |
| Body Part | V Metacarpophalangeal Joint, Left |
| Approach | 3 Percutaneous |
| Device | 5 External Fixation Device |
| Qualifier | Z No Qualifier |
Operation Definition
Taking out or off a device from a body part
Procedure Overview
Removal procedures on the upper joints take out a device that was previously placed in the joint during an earlier operation, without putting anything else in its place. This covers situations like extracting hardware such as pins, screws, or wires used for a prior fracture repair once the bone has healed, removing an infected or loosened joint spacer, or taking out sutures, anchors, or other fixation devices that are no longer needed or are causing problems.
These procedures are performed when a device has served its purpose, has failed, is causing pain or irritation, or has become infected and needs to come out before any further treatment can proceed.
Anatomy & Axis Detail
Metacarpophalangeal Joint, Left
The metacarpophalangeal joint on the left hand is the knuckle joint where the metacarpal head articulates with the proximal phalanx, stabilized by collateral ligaments and a volar plate that permit flexion for grip while resisting hyperextension. Removal here refers to taking out a nonbiological device previously placed in this joint, such as a silicone or pyrocarbon implant used to treat destructive rheumatoid or osteoarthritic changes, a failed prosthesis, or hardware from prior joint reconstruction. Because the joint sits just beneath thin dorsal skin and tendon, extraction requires care to avoid disrupting the extensor mechanism and surrounding neurovascular bundles. Documentation should specify the device removed and whether any joint lining or capsule material accompanied it, since retained cement or wear debris is coded separately from simple device extraction and affects downstream coding of any replacement procedure performed in the same encounter.
Approach: Percutaneous
Percutaneous describes entry by needle or instrument puncture through the skin or mucous membrane to reach the site of the procedure, without cutting the tissue open or using a visualizing scope. It differs from Open in that the site itself is never exposed, and from Percutaneous Endoscopic in that no endoscope is used to see internal structures. Common examples include needle biopsies and injections.
Device: External Fixation Device
This is the general external fixation device value, used when pins or wires anchored in bone are connected to a stabilizing frame outside the body to hold a fracture or joint in position, without specifying a more particular frame configuration. It contrasts with the more specific External Fixation Device subtypes - Monoplanar, Ring, Hybrid, and Limb Lengthening - which describe the frame's geometry or added lengthening function.
Coding & Documentation
Coding this family requires documentation that a device is being taken out and that nothing is being put in its place during the same operative episode - if a new device is implanted after removal, the procedure is coded instead as Replacement or Revision depending on what happened to the joint itself. The device type and its original purpose should be clear in the note to support the correct device value.
A common error is coding Removal for hardware taken out during a revision arthroplasty, when the removal of an old component and insertion of a new one in the same joint at the same session should instead be captured as a single Replacement procedure. Coders also sometimes overlook that removal of a device from a joint accompanied by repair of joint damage caused by that device requires an additional Repair or Revision code for the corrected tissue.