ICD-10-PCS Billable Code

0SRD07D

Replacement Knee Joint, Left to Medial Meniscus with Autologous Tissue Substitute, Open Approach

Procedural Specifications

Clinical Axis Detail Definition
Section0 Medical and Surgical
Body SystemS Lower Joints
OperationR Replacement
Body PartD Knee Joint, Left
Approach0 Open
Device7 Autologous Tissue Substitute
QualifierD Medial Meniscus

Operation Definition

Putting in or on biological or synthetic material that physically takes the place and/or function of all or a portion of a body part

Procedure Overview

Joint replacement in the lower extremities involves removing damaged or arthritic surfaces of a hip, knee, or ankle and implanting an artificial device that takes over the joint's function. Surgeons turn to this once medications, injections, and physical therapy no longer control the pain or stiffness of advanced osteoarthritis, rheumatoid arthritis, avascular necrosis, or a joint destroyed by prior trauma. The goal is restoring the ability to walk, climb stairs, and move without bone grinding on bone.

Implants are made of metal alloys, ceramic, or high-grade polyethylene, and a case can replace an entire joint (total) or a single compartment (partial). Recovery centers on physical therapy to build strength around the new joint; most patients regain substantial function within a few months, though the device will eventually wear and may need revision decades later.

Anatomy & Axis Detail

Knee Joint, Left

As with its right-sided counterpart, replacement of the left knee joint addresses the tibiofemoral articulation, substituting the damaged femoral condyles and tibial plateau with prosthetic components to restore alignment and function lost to osteoarthritis or joint failure. Surgeons choose fixation methods such as cemented, cementless, or hybrid techniques depending on bone quality, and the operative record should note whether the patella was also resurfaced, since this affects the overall procedure but not the primary knee joint code. Left-sided cases are coded distinctly from right-sided ones to support accurate tracking of staged or sequential bilateral knee replacements, which are common given the frequency of symmetric degenerative change.

Approach: Open

Open approach means the surgeon cuts through skin, mucous membrane, or other tissue layers to physically expose the target site to view before performing the procedure. It gives direct visualization and hands-on access, distinguishing it from Percutaneous approaches where instruments pass through a small puncture without exposing the site. Open is typical for procedures needing wide access, such as most laparotomies.

Device: Autologous Tissue Substitute

Autologous Tissue Substitute identifies a device value where material harvested from the patient's own body, such as an autograft, is used to replace or reconstruct a body part. Its defining feature is tissue origin from the patient, setting it apart from Nonautologous Tissue Substitute, sourced from a donor or animal, and Synthetic Substitute, made of manufactured material.

Qualifier: Medial Meniscus

Medial Meniscus specifies that a repair or supplement procedure on the knee joint targets the fibrocartilage pad on the inner (tibial) side of the joint. It is used in Medical and Surgical section codes for meniscal tears or degeneration repaired via suture or reinforcement rather than the excision root operations used for meniscectomy. The paired qualifier, Lateral Meniscus, identifies the same procedure performed on the outer cartilage instead.

Coding & Documentation

A coder assigns Replacement when the operative note documents removal of the native articular surface and insertion of a device meant to permanently substitute for it, not merely resurface it. Documentation should specify the joint, laterality, and whether the procedure was total or partial, since these drive qualifier selection. A common error is confusing partial resurfacing that leaves native bone intact with full Replacement, or missing that a revision arthroplasty swapping the entire prosthesis is still Replacement rather than Revision.

Commonly Confused With

RepositionReposition and Resection are most often mixed up with Replacement: Reposition realigns a joint without removing it, as in an osteotomy, while Resection removes the joint surface without inserting a substitute, as in a resection arthroplasty.
RevisionRevision addresses a malfunctioning or displaced device already in place and only becomes Replacement again if the entire prosthesis is exchanged for a new one.