0RSF34Z
Reposition Sternoclavicular Joint, Left to No Qualifier with Internal Fixation Device, Percutaneous Approach
Procedural Specifications
| Clinical Axis | Detail Definition |
|---|---|
| Section | 0 Medical and Surgical |
| Body System | R Upper Joints |
| Operation | S Reposition |
| Body Part | F Sternoclavicular Joint, Left |
| Approach | 3 Percutaneous |
| Device | 4 Internal Fixation Device |
| Qualifier | Z No Qualifier |
Operation Definition
Moving to its normal location, or other suitable location, all or a portion of a body part
Procedure Overview
Reposition procedures on the upper joints move a joint or a joint-related structure back to its normal alignment, or to another position that lets it function properly, without removing or replacing any tissue. The most common example is realigning a dislocated shoulder, elbow, wrist, or finger joint, though the same logic applies to correcting a joint that has drifted out of place due to a torn ligament, a healed fracture that set crookedly, or a congenital deformity. Surgeons may accomplish this through a closed manipulation under anesthesia or through an open surgical approach, sometimes anchoring the repositioned structure with wires, pins, or sutures.
Patients typically undergo this type of procedure after a traumatic injury, a chronic instability problem such as recurrent shoulder dislocation, or a structural deformity discovered during growth. The goal is restored range of motion, reduced pain, and prevention of further joint damage from continued malalignment. Recovery often includes a period of immobilization followed by physical therapy to rebuild strength and stability around the joint.
Anatomy & Axis Detail
Sternoclavicular Joint, Left
The left sternoclavicular joint is the articulation between the medial clavicle and the manubrium, reinforced by the costoclavicular ligament and an intra-articular disc that helps distribute forces transmitted from the arm to the trunk. Reposition is undertaken for dislocation, typically traumatic, where anterior displacement is more common but posterior displacement is more concerning due to its proximity to the trachea, esophagus, and great vessels immediately behind the joint. Correcting the clavicle's position restores normal shoulder girdle mechanics and eliminates pressure on these mediastinal structures, and because the joint offers little room for hardware, ligament-based stabilization is common; documentation should specify laterality to differentiate it from the right sternoclavicular or nearby acromioclavicular joint.
Approach: Percutaneous
Percutaneous describes entry by needle or instrument puncture through the skin or mucous membrane to reach the site of the procedure, without cutting the tissue open or using a visualizing scope. It differs from Open in that the site itself is never exposed, and from Percutaneous Endoscopic in that no endoscope is used to see internal structures. Common examples include needle biopsies and injections.
Device: Internal Fixation Device
Internal fixation device is the general value for hardware such as plates, screws, or rods placed within the body to stabilize bone or joint, used when a more specific configuration is not indicated. It stands in contrast to the named subtypes - Rigid Plate, Intramedullary, Sustained Compression, and Intramedullary Limb Lengthening - which specify how the hardware achieves stabilization.
Coding & Documentation
Coders assign a Reposition code when the operative note describes moving a joint, bone end, or periarticular structure to a normal or corrected anatomic position, whether by open reduction or closed manipulation. Documentation should specify the joint involved, the approach (open versus percutaneous versus external), and whether any device such as a pin or wire was left in place, since a separate Insertion code is needed if a device is used to hold the repositioned part. A frequent assignment error is confusing repositioning of a dislocated joint with reduction of a fracture, which is coded to a different body system if the fracture itself, rather than the joint, is the primary target. Coders also sometimes overlook that a closed reduction still qualifies as a Reposition even though no incision was made, and mistakenly search only under open-approach terminology.